Power wash a brick wall
Old red brick with black soot streaks running down from the cap and moss in the lower mortar joints.
Drag across the dirt to wash it.
Job done in . It is in your before and after album.
Paint on
Parts
(settings, album, streak and achievements, kept only in this browser)
This browser can't vibrate (iPhones can't), so big moments give a small screen shake instead.
What is on it
This brick wall has 3 kinds of grime, and each comes off its own way:
- Moss. Clings until you sweep across it at a low angle; then it peels in clumps. Holding still only soaks it.
- Algae. A slippery green film. Wide sprays work, but it slides ahead of the stream, so push it toward an edge.
- Soot. Greasy black dust. Water knocks most of it off but leaves a gray haze until soap or the brush cuts the grease.
How to wash it
Foam the soot and give the soap a few seconds to work, rinse the algae with the 25° or 40° fan, then sweep across the moss with the 15° nozzle so it peels in clumps.
It has 3 parts to bring to 100%:
- Cap stones: concrete
- Upper bricks: brick
- Lower bricks: brick
The grime is laid out from a seed, so this page always starts with the same mess. Tap New grime for a different one, or share the link to send someone this exact job.