Power wash a boat hull
A small boat hauled out after a season: a thick green beard below the waterline and rust running from the rail.
Drag across the dirt to wash it.
Job done in . It is in your before and after album.
Paint on
Parts
(settings, album, streak and achievements, kept only in this browser)
This browser can't vibrate (iPhones can't), so big moments give a small screen shake instead.
What is on it
This boat hull has 4 kinds of grime, and each comes off its own way:
- Rust. Water alone barely touches it. Foam it, wait a few seconds for the soap to work, then rinse.
- Stains. Soaked-in rings and blotches. Wide sprays only fade them; they need a close, narrow stream.
- Algae. A slippery green film. Wide sprays work, but it slides ahead of the stream, so push it toward an edge.
- Moss. Clings until you sweep across it at a low angle; then it peels in clumps. Holding still only soaks it.
How to wash it
Foam the rust and give the soap a few seconds to work, rinse the algae with the 25° or 40° fan, sweep across the moss with the 15° nozzle so it peels in clumps, then fade the stains with the 0° nozzle or turbo up close.
It has 5 parts to bring to 100%:
- Cabin: painted metal
- Upper hull: painted metal
- Waterline stripe: painted metal
- Lower hull: painted metal
- Rail: bare metal
The grime is laid out from a seed, so this page always starts with the same mess. Tap New grime for a different one, or share the link to send someone this exact job.